For 2024 Pilgrims: €50,- donation = 1 year with no ads on the forum + 90% off any 2024 Guide. More here. (Discount code sent to you by Private Message after your donation) |
---|
It would be helpful to have a photo of your good pole.All rules are broken at sometime or another. And I’ve just broken my rule of not getting on the Internet while I’m walking. But I’m not sure exactly what to do.
I have a pair of Black Diamond Distance FLZ poles. Yesterday one just kind of collapsed. I thought it was because the locking mechanism had come undone and so I was able to put it back together. But today, after a few kilometers, it’s very clear that the problem is more serious than that. Essentially the top joint piece slides all around and doesn’t seem to be anchored in any way. I am going to attach a couple of pictures, because my words are very inadequate to describe this. The pictures are intended to show the movement of this piece and how it isn’t secure anymore, if in fact it ever was. I am loathe to take apart my other pole to compare, because I’m afraid that will leave me with none instead of one.
But if anyone has any ideas, they would be very much appreciated.
In the last picture I have pushed the joint mechanism as as far as I can into the pole shaft on the left. And what you can see is a plastic or rubber sheet over the cord that seems to extend up and down the pole.
Try thisAll rules are broken at sometime or another. And I’ve just broken my rule of not getting on the Internet while I’m walking. But I’m not sure exactly what to do.
I have a pair of Black Diamond Distance FLZ poles. Yesterday one just kind of collapsed. I thought it was because the locking mechanism had come undone and so I was able to put it back together. But today, after a few kilometers, it’s very clear that the problem is more serious than that. Essentially the top joint piece slides all around and doesn’t seem to be anchored in any way. I am going to attach a couple of pictures, because my words are very inadequate to describe this. The pictures are intended to show the movement of this piece and how it isn’t secure anymore, if in fact it ever was. I am loathe to take apart my other pole to compare, because I’m afraid that will leave me with none instead of one.
But if anyone has any ideas, they would be very much appreciated.
In the last picture I have pushed the joint mechanism as as far as I can into the pole shaft on the left. And what you can see is a plastic or rubber sheet over the cord that seems to extend up and down the pole.
There seems to be a common problem with those poles and the video suggests how to correct this.All rules are broken at sometime or another. And I’ve just broken my rule of not getting on the Internet while I’m walking. But I’m not sure exactly what to do.
I have a pair of Black Diamond Distance FLZ poles. Yesterday one just kind of collapsed. I thought it was because the locking mechanism had come undone and so I was able to put it back together. But today, after a few kilometers, it’s very clear that the problem is more serious than that. Essentially the top joint piece slides all around and doesn’t seem to be anchored in any way. I am going to attach a couple of pictures, because my words are very inadequate to describe this. The pictures are intended to show the movement of this piece and how it isn’t secure anymore, if in fact it ever was. I am loathe to take apart my other pole to compare, because I’m afraid that will leave me with none instead of one.
But if anyone has any ideas, they would be very much appreciated.
In the last picture I have pushed the joint mechanism as as far as I can into the pole shaft on the left. And what you can see is a plastic or rubber sheet over the cord that seems to extend up and down the pole.
I don't think that it is supposed to go all the way in. I think that it is supposed to stick out and thereby stop the bits of the pole from wobbling about.In the last picture I have pushed the joint mechanism as as far as I can into the pole shaft on the left
Page 1 of the Engineer's Vade Mecum, page 2 includes such gems as "If it really won't budge try a Birmingham spanner." and "If it's a Whitworth thread, tighten it up until it shears then back off half a turn,"How to fix anything
Thats why you heat the tube. The hole will get larger and then as it cools it will get small again and tightly grip the taped piece. If it still can't fit you can try thinner tape wrapped around as much as needed to get it to just fit. This works in theory but I leave it to you to experiment in case the auto shop is closed.But if I am understanding how you are suggesting I use it, it is too thick to go between the shaft that’s loose and the outer shaft of the pole itself.
Usually I want to loosen things up. Would I use the right or left handed spanner."If it really won't budge try a Birmingham spanner."
Left handed spanners or les marteaux de Lyon are hard to find.Usually I want to loosen things up. Would I use the right or left handed spanner.
I suppose you could shim the gap with a strip of aluminum foil which is thinner than duct tape? Wrap it around the plug part and gently wiggle it into place, a firm wrench should be good enough to take it apart again for a more permanent repair later on.Thats why you heat the tube. The hole will get larger and then as it cools it will get small again and tightly grip the taped piece. If it still can't fit you can try thinner tape wrapped around as much as needed to get it to just fit. This works in theory but I leave it to you to experiment in case the auto shop is closed.
I tried this on my wife's FLZ pole, and the foil was too thick, and tore. I had better success with a wrap of thin plastic from a supermarket vegetable bag. Cling wrap might also work. You can experiment with how many layers you might need to get a good interference fit. I would also be trying to heat the outer tube only by slowly pouring some boiling water over just the section you want to expand a little. You will have to work fairly quickly, or perhaps enlist someone's help while you are doing this.I suppose you could shim the gap with a strip of aluminum foil which is thinner than duct tape? Wrap it around the plug part and gently wiggle it into place, a firm wrench should be good enough to take it apart again for a more permanent repair later on.
Pilgrim House is a non-profit organization providing welcome and services to pilgrims in Santiago. Forum member couple @natefaith manages it. For information about their operations in 2022, see this thread.Curious about this Pilgrim House.
Well believe it or not, I thought I had fixed it myself with some cling wrap. But no. I could not do the boiling water part of the fix but it seemed to me that it had made a secure connection.
I made it with one stick on a really hard stage today. So I don’t think it will be a crisis if I can’t find a garage or car repair shop to take a look. I am very hopeful I do see one though, because I would love to see how they could use their ingenuity to fix it.
I am four days out of Santiago, and plan to get a pair of sticks at Pilgrim House for my walk out to Muxia and Finisterre. So I should be OK.
Thanks everyone. I’ve written to black diamond and wonder what they will suggest.
I had same problem with my Distance Carbon Zs. Ferrule comes unglued from lower pole segment and slides all the way up into upper segment. I extract using approx 8mm screw to grab and pull it out. My field repairs included shimming with clear packing tape I keep on one of the poles, but after several hours, ferrule would work its way back up. Tried various other kinds of shims and super glue. Made it to end of Camino by checking every few hours and pushing ferrule back down. Black Diamond will tell you to cement ferrule back using marine grade epoxy. I used JB Weld as they recommended, but problem reoccured. Field repair was to use safety pin heated with bic lighter to drill small hole in UPPER pole segment; then leave pin in place to keep ferrule from sliding up. This made it all the way to end of second camino. Final solution was to epoxy all ferrules back in place, and then drill and pin all ferrules to poles with stainless wire.All rules are broken at sometime or another. And I’ve just broken my rule of not getting on the Internet while I’m walking. But I’m not sure exactly what to do.
I have a pair of Black Diamond Distance FLZ poles. Yesterday one just kind of collapsed. I thought it was because the locking mechanism had come undone and so I was able to put it back together. But today, after a few kilometers, it’s very clear that the problem is more serious than that. Essentially the top joint piece slides all around and doesn’t seem to be anchored in any way. I am going to attach a couple of pictures, because my words are very inadequate to describe this. The pictures are intended to show the movement of this piece and how it isn’t secure anymore, if in fact it ever was. I am loathe to take apart my other pole to compare, because I’m afraid that will leave me with none instead of one.
But if anyone has any ideas, they would be very much appreciated.
In the last picture I have pushed the joint mechanism as as far as I can into the pole shaft on the left. And what you can see is a plastic or rubber sheet over the cord that seems to extend up and down the pole.
Here's the thing I don't get... lightweight. They aren't on your back. And how much really are they lighter? C, I am glad u have had success with them. I haven't.I have used my Black Diamond folding poles for 8 Caminos over 10 years, and they are still going strong.
The frequency of problems may be higher than for more solid poles, but the convenience and lightweight are worth it to me.
Yes, I understand, but they are generally convenient and light for packing in my backpack to and from the Camino, or even on other occasions at home when I'm not sure if I will be using them. I'm not saying this is a deal-breaker, but they have served me very well.Here's the thing I don't get... lightweight.
Lightweight- Yay!! Lets me walk All Day. I walked my first Camino with generic telescoping aluminum poles. They helped a lot, and I learned that for my style of walking, one particular length was ideal for up/down/level walking. I used the poles very hard and wore out 3 pairs of tips in 3 days, even the "special" foot shaped tips they sold me in Pamplona. Finally, in Granon, Jesus gave me his personal tips, the large bulbous kind, and they made it all the way to Santiago, Muxia, Finisterre and the Camino Ingles. I think the total weight was about 1/2 kg. I learned of the Carbon Zs on that trek, so bought a pair upon return to USA. They weighed about 1/2 that of the telescoping poles, they were extremely maneuverable, especially on downhill rocky paths, and they take up much less length and bulk in my carry-on luggage. Fixed length means less time fiddling during collapse and assembly. Less weight means less wrist fatigue and less total weight on the feet. Black Diamond has replaced the wrist straps 2x, given me new pole ends, new carbide and new rubber tips when they wore out---Gratis.Here's the thing I don't get... lightweight. They aren't on your back. And how much really are they lighter? C, I am glad u have had success with them. I haven't.
I wouldn’t die in a ditch to defend my view but I’m with Damien on this; I’m also a sucker for ‘stuff’ and an ex-army economist and generalist manager : so categorically not an engineer.Lightweight- Yay!! Lets me walk All Day. I walked my first Camino with generic telescoping aluminum poles. They helped a lot, and I learned that for my style of walking, one particular length was ideal for up/down/level walking. I used the poles very hard and wore out 3 pairs of tips in 3 days, even the "special" foot shaped tips they sold me in Pamplona. Finally, in Granon, Jesus gave me his personal tips, the large bulbous kind, and they made it all the way to Santiago, Muxia, Finisterre and the Camino Ingles. I think the total weight was about 1/2 kg. I learned of the Carbon Zs on that trek, so bought a pair upon return to USA. They weighed about 1/2 that of the telescoping poles, they were extremely maneuverable, especially on downhill rocky paths, and they take up much less length and bulk in my carry-on luggage. Fixed length means less time fiddling during collapse and assembly. Less weight means less wrist fatigue and less total weight on the feet. Black Diamond has replaced the wrist straps 2x, given me new pole ends, new carbide and new rubber tips when they wore out---Gratis.
Your 3-section aluminums may well serve as a better defense in that situation, than my floppy BDs.I wouldn’t die in a ditch to defend my view
Hey, just answering the question on how to repair BD's and the question, "Here's the thing I don't get... lightweight." Everyone is entitled to use what works best for them.I wouldn’t die in a ditch to defend my view but I’m with Damien on this; I’m also a sucker for ‘stuff’ and an ex-army economist and generalist manager : so categorically not an engineer.
At any point when I’m walking, one of my poles is in contact with the floor. I know there’s going to be some fancy-pants engineering explanation which refutes my view, but in my simple mind, if it’s on the floor I’m not carrying it.
Then we can look at thin things vs thick things (thick = stronger is as far as my logic goes - yes, I know it depends on the material, but if you shock it at 90 degrees the difference seems to diminish) and number of components (more = greater likelihood of failure) and degree of sophistication (simple = better; may overlap with previous criteria) and finally cost.
I’ve got the lot: BD carbon fibre z-poles; similar knock-offs; a selection of Leki’s and some no-name 3-section aluminums. It is the latter which have seen me through numerous caminos.
On my 5 year old ZZs, leave top handle loose (unclicked); leave bottom piece apart from middle, and connect the top to middle. Then pull bottom until the shock cord comes out of the middle and exposes a slotted adjustment screw. Unscrew it a few turns to lengthen the shock cord and see if that gives you enough slack to lock the handle.I have tried again, one last time before Santiago. There was a roll of scotch tape at the reception desk in my Hostal last night, so I gave it a try. It actually seemed to work, in that it could anchor the inside piece, and the top piece could be pushed over it. But then, no matter how I position the inside shaft, I am incapable of pulling it so that the lock triggers. What I mean by that is that I can’t extend the pole enough so that the locking mechanism pops out.
What I can’t figure out is whether I should push the inside shaft down further or move it up more in order to facilitate the locking mechanism. If all of this sounds like gobbledygook just ignore. I think I’ll make it to Santiago today.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?